Lopi Horizontal Or Vertical Vent Freestanding Stove Yankee Pellet Stove - Manual (Page 41)

Optional Equipment
4 1
Travis Industries
4050418
1 0 0 - 0 1 1 5 6
Remote Thermostat
• Follow the instructions included with the remote thermostat for installation.
Using the Remote Thermostat
The remote thermostat has a 1 to 2 minute lag time between the time the thermostat is turned up and
the heater turns on. Included with the remote thermostat is a set of instructions that details the
operating characteristics of this optional component.
Pellet Log (part # 98900126)
1 Assemble the log shelf (with log shelf extender) following the directions below.
Right Log Shelf Leg
Left Log Shelf Leg
Log Shelf Cross Brace
3/8" Nutdriver
Nuts
Slide the log shelf extender onto the log shelf
assembly. Use a hammer to tap the extender
fully into place.
Log Shelf
Extender
The log shelf assembly should
like like this when done.
2 Remove the firepot from the pellet stove. Center the log shelf assembly (with extender attached)
over the burnpot holder. Replace the burnpot. Place the log on the log shelf extender. When in
place the log should appear as shown in the picture below.
Center the log
shelf over the
burnpot holder.
Slide it all the way
back against the
fireback.
a
b
Remove
the
burnpot.
Center the log on the log shelf
extender and push it back so it
rests against these two pins.
Replace the
burnpot.
c
d
The log should look
like this when
installed.