Lopi Yankee Bay Pellet Insert - Manual (Page 38)

3 8
Optional Equipment
Travis Industries 4 0 5 0 5 0 9 1 0 0 - 0 1 1 4 5
Remote Thermostat (Part # 99300653)
• Follow the instructions included with the remote thermostat for installation and operation.
Optional Log (Part # 98900126)
! Make sure the heater has fully
cooled before installation.
1 Open the door (see the instructions
included with the owner’s manual.
2 Attach the two log shelf legs to the
cross brace with the four included
nuts. Make sure to use the correct
leg for each side.
•
Install the log shelf assembly and log
following the directions below.
Right Log Shelf Leg
Left Log Shelf Leg
Log Shelf Cross Brace
3/8" Nutdriver
Nuts
Center the log on the log shelf and
push it back so it rests against
these two tabs.
Place the log shelf assembly so the
back edge contacts the cast firebrick
in the rear of the firebox. Note how
the taper on the assembly matches
the taper on the cast firebrick.
a
b
NOTE:
On inserts, the ash box must be
installed before placing the log shelf
assembly.
When in place, the log should appear as
shown in the photograph to the right.