Leggett & Platt P-2000 - Manual (Page 7)

OPERATION
P-2000 OPERATING INSTRUCTIONS
Head Massage Arrow Buttons:
Slowly increases or decreases
speed of the massager as long as
the appropriate button is pressed.
Massage Set Button:
Once desired settings of the
massagers and wave have been
activated, press this button to save
those settings for the Favorite
Massage Button.
Head Up/Down Rocker Switch:
Adjusts the head section of the bed
to the desired position.
Head Massage On/Off Button:
Turns massager on or off. When turned
on, the massage has an automatic shut
off timer of 30 minutes.
Wave Arrow Buttons:
Once one or both massagers are
activated, this button turns the wave
feature on or off.
Wave On/Off Button:
These buttons increase or decrease
the speed of the wave feature as
long as the appropriate button is
pressed.
Foot Massage Arrow Button:
Slowly increases or decreases
speed of the massager as long as
the appropriate button is pressed.
Foot Up/Down Rocker Switch:
Adjusts foot section of the bed to the
desired position.
Foot Massage On/Off Button:
Turns massager on or off. When
turned on, the massage has an
automatic shut off timer of 30
minutes.
6
Transmission Indicator Light:
Verifies a button is being pressed.
AUTO LEARN FEATURE: This feature is used to reprogram your remote, or to program a new remote.
Unplug the bed from the wall, then plug it back in. Press and hold the POS1 button and the Head Massage
ON/OFF buttons on the remote. The transmission light will flash slowly and then flash rapidly. Continue to
hold for 2 seconds and then release. The code for the new hand control has been learned.
REQUIRES FOUR (4) “AAA” BATTERIES
Flat Button:
Massagers will turn off and the
bed will move to the flat position.
Position Buttons: (see note below)
Automatically moves bed to the preset
position from any other setting. To stop
the bed while in motion, press and hold
any button until the bed stops.
Favorite Massage Button:
Press and hold this button to turn on
massager to the programmed setting.
FOR RADIO FREQUENCY AND FCC INFORMATION, SEE PAGE 2.
NOTE: The POS1, POS2 and POS3 buttons are not programmable. They are preset
and can not be changed.