Lowrance electronic iFINDER M-M - Manual (Page 66)

60
tude/longitude (Starting Position) or from a stored waypoint, map place
or POI location (Select Starting Waypoint). You can steer your position
on the map by using the arrow keys (
S TEER W / A RROWS
) or by setting the
track and speed in the boxes provided on simulator screen.
To get to the GPS Simulator:
1. Press
MENU | MENU |
↓ to
GPS S
ETUP
| ENT .
2. Press
↓ to
GPS S IMULATOR
| ENT .
The GPS Simulator Menu.
Make the desired settings, then turn the simulator on by highlighting the
S IMULATOR O N
box and pressing ENT key. Press EXIT to erase this menu. A
message appears periodically, reminding you that the simulator is on. To
turn the simulator off, repeat the above steps or turn the unit off.
While in simulator mode, you can press EXIT to clear the steering and
speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor during a simulation. To turn steering
and speed boxes back on again, return to the GPS Simulator menu, se-
lect the
S
TEER WITH
A
RROWS
command, and press ENT , then press
EXIT | EXIT | EXIT to return to the previous page.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a S TARTING P O-
SITION
at or near the beginning of your trail/route. Enter an approximate
T
RACK
(shown in compass degrees) that will point you toward the start
of the trail/route.
offered by www.Busse-Yachtshop.de email: [email protected] Tel: +49 (0)4347 908234