Lifetime #7525 - Manual (Page 9)

9
Required For This Page:
/2” Wrench
Electric Drill/
Screwdriver
RG
RF
RF
RJ
25.1 Place the Spring Retainer
Plate (RJ) and secure with Nylock
Flange Nuts (RF).
RJ
(Not actual size)
()
RF
(2)
3/4” Wrenches
HD985
24.1 Place the Compression
Springs (RG) over the ends of the
U-Bolt (RE).
MX
MY
(2)
(2)
MX MX
MX
26.1 Slide a Carriage Bolt (MX) into the
crimped slot in each Backboard channel.
28.1 Bend the Backboard Brackets (AP &
AQ) out and over the Carriage Bolt (MX).
AQ
MY
MY
AP
28.3 Completely tighten all
Rim hardware.
Note: Do not overtighten the Nuts (MY).
Note: The lower holes should go
over the Carriage Bolts.
26
28
28.2 Secure Brackets with 5/16 “
Nylock Flange Nuts (MY).
25 24
27.1 Attach the Rim Cover Plate (AX) to the Rim using
#7 x 3/8” Screws (RA).
27
RA
AX
003678
RA
(4)
Note: Do not overtighten the Nuts (RF).