Audio controls & video status – Lexicon RV-5 User Manual

Page 63

Advertising
background image

RV-5

Audio Controls & Video Status

4-3

To load a different saved EQ Preset into the system:

1. Decide which saved Preset location you want to load.

2. Select ACTIVE PS from the EQ PRESET menu.

3. Use the

or

cursors to select the Preset location you want

to load.

4. Press the

cursor to save the selection.

When the Active PS is set to “USER”, this indicates a factory default
condition.

Note: Once a Preset location has been selected and saved, the factory
default “USER” option is no longer available for selection. Before a preset
location is saved, toggling the EQ on & off results in a noticeable change in
the subwoofer output level. This is normal behavior.

HF SHELF

+8dB to -8dB

Located in the EQ ADJUST menu, the HF SHELF control acts as a
high-frequency shelf filter, which boosts or cuts frequencies above
1kHz. The HF SHELF parameter can be adjusted from +8dB to -8dB
in 1dB increments.

Note: The HF SHELF parameter does not adjust the timbre of the rear
speakers in the 7-CHANNEL listening mode.

TONE CONTROLS

OFF, ON

Activates or deactivates the Bass and Treble Tone Controls. Bass and
Treble controls are only active when the Tone Control parameter is
set to ON.

Note: When the Tone Controls are OFF, the incoming audio datastream is
stereo analog, and the Mode Family is set to STEREO, four different listening
modes are available: 7CH STEREO, 5CH STEREO, 2CH STEREO, and 2CH
BYPASS. Refer to the “Listening Modes” section of
Section 3: Setup for more
information.

BASS

+6dB to -6dB

Controls the amount of low-frequency boost or cut applied to all of
the audio outputs. Bass is an independent setting for each input,
NOT a global setting. The BASS parameter can be adjusted from
+6dB to -6dB in 1dB increments.

TREBLE

+6dB to -6dB

Controls the amount of high-frequency boost or cut applied to all
of the audio outputs except for the subwoofers. Treble is an
independent setting for each input, NOT a global setting. The
TREBLE parameter can be adjusted from +6dB to -6dB in 1dB
increments.

AUDIO CONTROLS

EQ ADJUST

HF SHELF

AUDIO CONTROLS

TONE CONTROLS: OFF

AUDIO CONTROLS

BASS

AUDIO CONTROLS

TREBLE

Advertising