Line 6 3.7 - Manual (Page 18)

Line 6 GearBox 3.7 – Using Your Line 6 Hardware
2•11
TonePort KB37
Connect any line
level input source for
monitoring to the
Stereo Monitor In
Connect any line level input
source that you want to
record into the Line Inputs
Connect your electric
Guitar or Bass
Connect up to two standard toggle
or momentary pedal switches into
the Footswitches jacks for remote
control of GearBox and audio
application
Connect the Analog Outs
to your audio monitors
Connect your USB cable
from your computer’s USB
port.*
Connect
your stereo
Headphones
Connect up to two
Microphones
Connect to the S/PDIF input
of an external device to send
TonePort’s output digitally
Connect an
Expression Pedal
here for control of
MIDI parameters
Microphone Inputs - You can receive input from one or two mics at the same time using these ins.
There is also a +48V Phantom Power switch that you should toggle to “on” if your mic requires
phantom power (most condenser type mics do, but check the documentation for your mic if you are
not sure). Connect each mic using an XLR cable. This inputs each microphone signal independently
into GearBox where you can choose your tone, and then route the processed signal both to your audio
software and out the TonePort outputs.
Guitar/Bass Input -To connect your electric guitar or bass, plug it into this input. This connection
routes the instrument’s signal into GearBox where you can choose your tone and route the processed
signal both to your audio software and out the TonePort outputs. This input also features a Pad switch;
engage this switch when using a guitar/bass with high-output or active pickups, to avoid overdriving
the input.
Headphones - If you want to listen to the audio from TonePort using stereo headphones, then plug
them into this 1/4-inch stereo jack. This Headphone jack outputs the same signal fed to the Analog
Outs on the rear panel of TonePort; the audio from your audio software on the computer, as well as
anything plugged into any TonePort input.
Line Inputs - if you want to record the signal from a line level source, such as a keyboard, your stereo
receiver, the line out from a mixing console, etc., connect them to these Left and Right ins using 1/4-
inch TS audio cables.
Footswitches - if you want to use one or two on/off toggle or momentary footswitches to remotely
control functions in the GearBox software, you can plug the 1/4-inch footswitch plugs into these
1 and 2 jacks. To configure each Footswitch, go to the GearBox Preferences. You can also use these
footswitches to trigger recording and playback commands within the included Ableton Live Lite 5
software!