Polycom SpectraLink 1725-36143-001 - Manual (Page 12)

LinkPlus Interface Guide: Siemens Hicom/HiPath optiset for SpectraLink e340/h340/i640 Wireless Telephones
PN: 1725-36143-001_K.doc 12
OptiGuide menu
The OptiGuide menu provides access to features appropriate to the
current context of the handset. You may navigate through the menus
by using the default programming:
FCN + * (Previous), FCN + 0
(Select), FCN + # (Next). Navigation and selection options should be
programmed to the softkeys as described in the following section. To
access the off-hook features of the OptiGuide menu, place the handset
in the off-hook active mode by pressing
Start Call . To access the on-
hook features, press Start Call again to enter the on-hook active mode.
Pressing the Start Call key again will return the handset to the off-hook
active mode. Press the End Call key to enter the standby mode.
In the Hicom 150 and HiPath 3000 systems the optiset E Basic
telephone does not have OptiGuide context-sensitive feature keys.
However, the key codes used for the OptiGuide keys are recognized
by the host Hicom CS and can be used on the handset. Refer to the
key-map diagram notes.
Prime Line impacts
If a handset is used in conjunction with an optiset desk telephone,
each phone is configured on the Hicom CS as an independent phone
with its own phone number (each device is assigned to a separate
Prime Line). In order for both an optiset E telephone and a handset to
ring together, the extensions need to be set up at the Hicom CS to ring
at the same time.
A called party’s display of the originating line will be different when
the handset makes the call compared to the optiset telephone. The
name text could identify the source of the call to avoid confusion. For
example, the display name of the handset could be stored as “Smith
WT” at the Hicom CS. Display names should be kept to a minimum
so the full name is displayed on the handset (see the SpectraLink
Wireless Telephone section above for more details).
It should also be noted that the class of service (COS) of the handset is
related to the Prime Line of the phone and not the line appearance.
Speed dial
Users should be made aware that stored speed dial and redial
features will have to be saved separately for the optiset E telephone
and the handset. Additionally, the Last Number Redial feature will
only apply to the device from where the original number was dialed.