Pinnacle Speakers TG475-2 - Manual (Page 6)

FUEL REGULATOR AND HOSE
The fuel regulator supplied is equipped with a
Type 1 coupling nut. Do not attempt to con-
nect to any other L.P. cylinder not equipped
with a mating Type 1 cylinder valve. This grill
is not to be used with any other cylinder con-
nection device.
The fuel regulator and hose assembly with the
Type 1 fitting supplied must be used with the
appliance. Do not use a hose and regulator
assembly other than the one supplied with the
grill or a manufacturer’s replacement fuel
pressure regulator assembly.
The Type 1 connection system has the follow-
ing features:
1. The system will not allow gas to flow until
a positive connection has been made.
2. The system has a thermal element that will
shut off the flow of gas between 240°F and
300°F.
3. The system has a flow-limiting device
which, when activated, will limit the flow of
gas to 10 cubic feet per hour.
4. The pressure regulator and hose assem-
bly provided is factory set at an outlet
pressure of 11 inches water column (.4 lb.
per sq. Inch).
WARNING: Any attempt to adjust the regu-
lator is dangerous and could create a situa-
tion causing personal injury or property dam-
age. Consult your L.P. gas dealer if you think
the regulator is not working properly.
L.P. GAS SUPPLY CYLINDER
L.P. Cylinders can be obtained at the store
where you purchased your grill or from an
authorized L.P. gas dealer.
L.P. GAS CYLINDER SPECIFICATIONS
Any L.P. gas-supply cylinder used with this
grill must be approximately 12 inches
diameter and 18 inches high. The maximum
fuel capacity must be 20 pounds of propane.
Full-cylinder weight should be approximately
38 pounds (43.7 lbs. Nominal water
capacity).
Multi-Burner Fuel-
Control Valve
Assembly
The L.P. Fuel Supply System
(the fuel regulator and hose)
Fuel Supply
Hose
Type 1 Fuel
Regulator
Side Burner
Control Valve
Cylinder Control
Valve
L.P. Gas
Cylinder
NOTE:
L.P. Gas
Cylinder
NOT
INCLUDED
The L.P. Fuel Supply System
(L.P. gas cylinder)
6