Polycom SpectraLink 6300 MCU - Manual (Page 44)

Facility Preparation: SpectraLink 6000 System: SpectraLink 6300 MCU
PN: 1725-36121-001_J.doc 44
† One (or two) cross-connect block(s) are installed for every
Interface Module and connected with a 25-pair telco cable
terminated with an RJ-21 male connector at the MCU location as
shown in Chapter 3 sections Install Demarc Blocks and Program
Telephone System.
† The Base Station cables are terminated at the appropriate cross-
connect blocks. See Chapter 3 section Connect Cables from Base
Stations and Phone Lines to Demarc Blocks.
† Analog or digital ports, one per handset, from the switch is
terminated at the appropriate cross-connect block and the block is
labeled with the extensions. See Chapter 3 section Connect Cables
from Base Stations and Phone Lines to Demarc Blocks.
† A dedicated dial line (MB) is available with an RJ-11 jack for the
diagnostic modem.
† An IBM-compatible PC is available to serve as the Operator’s
Console for system administration. See Chapter 2, section
Operator’s Console.
† A system administrator is designated for the SpectraLink 6000
System. This person should be present for the installation. The
Polycom field service engineer will provide system training to the
system administrator on the day following the installation.
When this checklist is completed please sign, date, and fax to
Install Coordination at 303-449-7016.
Signature: _______________________________
Date: ___________________________________
If you have any questions regarding the installation procedure, please
call the Polycom Customer Support Hotline at 800-775-5330 (Monday
through Friday, 6 a.m. to 6 p.m. Mountain time).