Polycom 2300 User Manual
Page 8
Configuration Guide
PN: 1725-36082-001_F.doc
8
Configuring a New WLAN Security Switch
Starting from Factory Defaults
1. Using the supplied DB-9 male to DB-9 female standard RS-232
cable, connect the WLAN Security Switch to the serial port of a
terminal or PC.
2. Run a terminal emulation program (such as HyperTerminal) or
use a VT-100 terminal with the following configuration:
Bits per second:
9600
Data bits:
8
Parity: None
Stop bits:
1
Flow control:
None
3. Power-on the WLAN Security Switch. The status of the boot
process will appear in the console as the switch is powering up.
Once the switch is operational you will be presented with a login
prompt.
4. A Quick Start Wizard provides for an easy means to perform
initial WLAN Security Switch setup and configuration. Refer to
the WLAN Security Switch 2300 Series Quick Start Guide found at
Nortel’s Technical Support site. This document contains a detailed
explanation of using the Startup Wizard:
5. Once the WLAN Security Switch has been configured via the
Quick Start Wizard, the remaining configuration can be
performed using command line interface (CLI), Web View or
WLAN Management Software (WMS). Configuration examples
will be provided for both CLI and WMS.
6. If necessary, the WLAN Security Switch may be reset to factory
defaults. To reset the WLAN Security Switch to factory defaults,
you must issue the “clear boot config” command via the console.