Polycom DOC2564A - Manual (Page 13)

13
21 In the Span Definition dialog box, define the following parameters:
22 Click Next.
The Phones dialog box opens.
23 To define dial-in number ranges click the Add button.
24 In the Add Phone Number dialog box, define the first and the last
numbers in the phone number range.
25 Click OK.
The new range is added to the Dial-in Phone Numbers table.
Field Description
Framing Select the Framing format used by the carrier for the
network interface from the list.
• For T1 spans, default is SFSF.
• For E1 spans, default is FEBE.
Side Select the RMX side on the network.
Default: User side
Note: If the PBX is configured on the network side,
then the RMX unit must be configured as the user
side, and vice versa, or both must be configured
symmetrically.
Line Coding Select the PRI line coding method from the list.
• For T1 spans, default is B8ZS.
• For E1 spans, default is HDB3.
Switch Type Select the brand and revision level of switch
equipment installed in the service provider’s central
office.
• For T1 spans, default is AT&T 4ESS.
• For E1 spans, default is EURO ISDN.
• A range must include at least two dial-in numbers.
• A range cannot exceed 1000 numbers.