Pengo Computer Accessories EQUITY SERIES COMPUTER 386SX - Manual (Page 5)

EQUITY 386SX
Installation/Support Tips
Power
The Equity a power supply is switchable
between for USA and Canadian and for
in other countries. The voltage switch is located at
the rear of the CPU between the AC inlet and the AC
outlet.
below)
voltage not changed between
the AC inlet and the AC outlet. If the CPU is
for in order to function in Europe, only
peripherals for use at should be
plugged into the
hard disk
CPU SPEEO
Installing Floppy Disk Drives
When installing a floppy disk drive as drive
remember to set the drive select jumper to the
second position and attach the pas&through
Equity Series Computers
connector on the cable
If the not normally, make
in SETUP. that any
been installed correctly.
Installing Hard Disk Drives
It is recommended that a AT-type hard
disk controller be used in the
you are installing a that cannot make use
of the internal hard
remember to the hard disk
controller when such
a
you are having in formatting the
option In
setup
When an expanded memory
board, do not list the memory under the
memory
in SETUP. That
option is for EXTENDED memory ONLY.
a hard disk drive, be sure to
for the type which fits the
you are installing.
Adding Memory Modules
The total amount of memory must be one of
the following: 1 MB,
12MB or 14MB.
Memory banks must be filled with one size
SIMM. You cannot mix SIMM types in one
bank.
The rest of the accept
only 1 MB The SIMM sockets
must be filled before using any of the 1 MB
sockets.
Software Problems
When installing a copy-protected software
package on the Equity 888% first try the
EQ386SX-5