Polycom Video Media Center VMC 1000 - Manual (Page 7)

Setting Up the VMC 1000 Appliance
Polycom, Inc. 3
WARNING
• To avoid electrical shock, check the power cords as follows.
• This product is to be installed in Restricted Access Location only.
• Use the exact type of power cords required.
• Use power cord(s) that came with safety certifications.
• Power cord(s) must comply with AC voltage requirements in your region.
• The power cord plug cap must have an electrical current rating that is at
least 125% of the electrical current rating of this product.
• The power cord plug cap that plugs into the AC receptacle on the power
supply must be an IEC 320, sheet C13, type female connector.
• Plug the power cord(s) into a socket that is properly grounded before
turning on the power.
WARNING
Disconnect the power supply at the circuit breaker before accessing the C-2400
power supply or any other of its components. Turning off the system power
supply switch does not reduce the risk of electrical shock from the power
supply terminal block.
CAUTION
Risk of explosion if CMOS battery is installed upside down or is replaced by
an incorrect type. Dispose of used batteries according to the instructions.
CAUTION
Required operating conditions for the appliance are -
• Temperature: 10 to 35oC.
• Humidity, non-condensing: 8 to 90%.
CAUTION
• To prevent the unit from overheating, never install the appliance in an
enclosed area that is not properly ventilated or cooled. For proper airflow,
keep the front and back sides of the appliance clear of obstructions and
away from the exhaust of other equipment.
• Be aware of the locations of the power switches on the chassis and in the
room, so you can disconnect the power supply if an accident occurs.
• Take extra precautionary measures when working with high voltage
components.