Polycom RSS 2000 - Manual (Page 31)

RSS 2000 Policies and Limitations
23
RSS 2000 Policies and Limitations
Table 8 Policies and Limitations
Subject Description
H.323 Alias length The maximum length of the system H.323 alias name is 16 characters.
Console Service
RS232 configuration: Baud rate 9600, Data bits 8, Parity None, Stop
bits 1, Flow control OFF.
ONLY ONE connection to the Console service is allowed at any time,
either by RS232 or by Telnet, but not both.
Endpoint menu
ƒ When scheduling a dial out & record from the Web UI, RSS will
loopback the video and NEVER show the menu unless a menu
operation command (FECC arrow keys or DTMF 2/4/6/8) is given
from the endpoint.
ƒ When a pre-defined endpoint dials into the RSS and the endpoint has
the "immediate recording" option, RSS will never show the menu
unless a menu operation command is given.
ƒ When inviting an endpoint to a P2P recording room (using E.164
number of the P2P room followed by # or * and E.164 number of the
invited endpoint), the inviting endpoint will view menu and the invited
endpoint will not view the menu.
ƒ When two endpoints meet at a P2P recording room, only one of them
can view the menu at a time.
P2P recording
maximum bandwidth
Maximum bandwidth for a P2P recording room is 1024K. If video
protocol for P2P recording room is H.264, then the maximum
bandwidth is 768K.
Archive file size
If the media file size exceeds 4GB, downloads from Web UI may be
incomplete.
Media Player
Support
Windows Media Player 9 or above is required..
RealPlayer can also be used if WMP is properly installed.
QuickTime player is not supported.
Some third party media player such as Media Player Classic (MPC)
and VLC can also be used, but they were not tested and are not
supported.
Archive playback
Archive playback with WMP does not support playback controls:
Pause/Resume/FF/Backward, etc
H.323 playback
During H.323 playback, if there is packet loss and the endpoint
requests an I-Frame, RSS cannot honor the request because all
audio/video data are from the media file with I-Frames already set.
System Reset
Hard reset (power off and on) is not recommended.
Reset should be done via the Web UI or Console service whenever
possible.
LDAP integration Only Microsoft Active Directory is supported.