Progressive Turf Equipment SDR 90 - Manual (Page 23)

23
TROUBLE SHOOTING:
PROBLEM CAUSE REMEDY
Belt slippage Lack of tension
oily drive conditions Increase tension
Clean up drive
Rapid belt wear Belt slippage
belt not in proper
groove Increase tension
Place in proper groove
Belt squeal Belt slippage Increase tension
Over-heated bearings Belt slippage
excessive drive tension Increase Tension
Tension drive properly
Input shaft does not
collapse easily on
turning.
Premature spindle
bearing failure.
Lack of grease at
intermediate location of
drive shaft
Lack of lubrication or
grease is contaminated
Remove driveshaft and
pull apart. Grease
splines. Grease every 8
hours.
See grease information
and ensure grease being
used is compatible.
Grease per instructions