Polycom KIRK 14171914-HD User Manual
Page 14
14
opportunity to maintain uninterrupted
telephone service. If you experience trou-
ble with this telephone system, disconnect
it from the network until the problem has
been corrected or until you are sure that
the equipment is not malfunctioning.
Note: This equipment has been tested and
found to comply with the limits for a class
B digital device, pursuant to local
regulations. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates,
uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation. If this
equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the
following measures:
— Reorient or relocate the receiving
antenna.
— Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
— Consult the dealer or an experienced
radio/TV technician for help.
FCC Note: This device complies with part
15 of the FCC rules. Operation is subject
to the following two conditions: (1) This
device may not cause harmful interfer-
ence, and (2) this device must accept any
interference received, including interfer-
ence that may cause undesired operation.
SAR: Device has been tested for SAR
compliance for head and body worn con-
figurations. The highest reported SAR
values are: head 0.049 W/kg (5020) /
0.206 W/kg (5040), and body worn 0.075
W/kg (5020) / 0.330 W/kg (5040).
IC Note: Operation is subject to the fol-
KIRK 5020 5040 UK_FR_DE_ES_IT.book Page 14 Thursday, February 25, 2010