Polycom RSS 2000 - Manual (Page 2)

DOC2207A RSS 2000 V3.0 Getting Started guide - Release Note - Final - February 26, 2008.doc
Preparations
Obtain the following information from your network administrator:
• RSS 2000 unit, Subnet Mask and Default Gateway IP addresses
• Gatekeeper IP address, Prefix, and E.164 of the RSS 2000.
Unpacking and Installing the RSS 2000
1 Place the RSS 2000 unit on a stable flat surface in the selected location.
2 To connect to the power source, insert the power cable into the
Power connector on the rear panel of the MGC+ unit and insert the
Power cable into the power source socket.
3 Connect the lan cable to LAN1 in the back of the system.
4 Turn on the power switch.