Polycom AS-2000 - Manual (Page 3)

Airespace Wireless Enterprise Platform—AireOS AS-2000 Switch Controller with AP10-xx Access Point
PN: 1725-36047-001_G.doc 3
Introduction
Customers have reported that the WLAN products described in this
document operate adequately with SpectraLink Wireless Telephones
at their location using the software version listed below. For Field
Verified WLAN products, Polycom has not conducted any testing and
therefore cannot guarantee interoperability or performance. Polycom
technical support of interoperability issues for WLAN products
running versions of software not listed in the table may be subject to
time and materials charges.
This document describes the configuration of the Airespace Wireless
Enterprise Platform and the AireOS for best known operation with
SpectraLink Wireless Telephones.
Product Summary
Manufacturer: Airespace: www.cisco.com
Approved product(s) : AS-2000 switch/controller with AP-10xx access point
RF technology: Direct-sequence spread spectrum (DS), 2.4 GHz
Radio: 2.4 – 2.484 GHz (802.11b/g)
Required AP software version: Firmware version 2.0 †
SpectraLink handset models: ** e340/h340/i640 8020/8030
SpectraLink radio mode: 802.11b 802.11b
Maximum telephone calls per AP: 12 * 12 *
AP configuration parameters: See Access Point Configuration below
Indoor range (typical): See vendor specifications for AP
Required network topology: Switched Ethernet
Network constraints: Dedicated segment for wireless, single subnet
WEP capability: Yes *
ESSID auto-learn function: Yes *
† Earlier and later software versions have not been validated except as noted.
* Telephone calls per AP must be configured in the system per documentation provided by Polycom.
** SpectraLink handset models 8020/8030, e340/h340/i640 and their OEM derivates are known
interoperable at one or more customer sites with the WLAN hardware and software identified in the
table. Throughout the remainder of this document they will be referred to collectively as “SpectraLink
Wireless Telephones”.