Polycom 1725-31402-001 - Manual (Page 111)

Release Notes - UC Software Changes
Copyright © 2011 Polycom, Inc. Page 103
sip added softkey.x.label This is the text displayed with the soft
key.
If set to Null, the label to display is
determined as follows:
• If the soft key is mapped to a
enhanced feature key macro, the
label of the enhanced feature key
macro will be used.
• If the soft key is mapped to a speed
dial, the label of the corresponding
directory entry will be used. If this
label does not exist as well and the
directory entry is an enhanced feature
key macro, then the label of the
enhanced feature key macro will be
used.
• If the soft key is mapped to chained
actions, only the first one is
considered for label, using the rules
above.
• If no labels are found after the
above steps, the soft key label will be
blank.
sip added softkey.x.action The same syntax as the enhanced
feature key action.
sip added softkey.x.enable If set to 0 or Null, the soft key is
disabled.
If set to 1, the soft key is enabled.
sip added softkey.x.precede If set to 0 or Null, the soft key
replaces any empty space from the
leftmost position.
If set to 1, the soft key is displayed
before the first standard soft key.
sip added softkey.x.use.idle If set to 0 or Null, the soft key is not
displayed in the idle state.
If set to 1, the soft key is displayed in
the idle state.
sip added softkey.x.use.active If set to 0 or Null, the soft key is not
displayed in the active call state.
If set to 1, the soft key is displayed in
the active call state.
sip added softkey.x.use.alerting If set to 0 or Null, the soft key is not
displayed in the alerting state.
If set to 1, the soft key is displayed in
the alerting state.
sip added softkey.x.use.dialtone If set to 0 or Null, the soft key is not
displayed in the dialtone state.
If set to 1, the soft key is displayed in
the dialtone state.
sip added softkey.x.use.proceeding If set to 0 or Null, the soft key is not
displayed in the proceeding state.
If set to 1, the soft key is displayed in
the proceeding state.
sip added softkey.x.use.setup If set to 0 or Null, the soft key is not
displayed in the setup state.
If set to 1, the soft key is displayed in
the setup state.