Primera Technology RX900 - Manual (Page 44)

40 Printing
TOF. Decrease the Top of form by 10. This will cause the
printer to start printing before the label and ensure a fully
printed label.
Note: It is best to over bleed as little as possible to avoid excess ink on the
label backing. Also, over bleeding too much will cause the printer to
skip labels. This is because the printer stops printing too late to sense
the next label.
F. PRINTER DRIVER SETTINGS
Once the printer driver has been successfully installed, you
will need to setup the driver with the appropriate print
options. Refer to the following steps to change or verify your
default printer driver preferences. These settings will apply to
all new designs created in NiceLabel or other programs after
the preferences were changed. Existing labels saved in
NiceLabel will not be affected since the preferences are saved
with the label. To change these preferences you will have to
change printer preferences through NiceLabel. (File Menu -
Printer Settings)
Actual Label Stock
Size = 2” x 2”
Over Bleed Page Size
2.1” x 2.1” (.1 Inch)
Decrease TOF by 10
Decrease Left Margin
Offset by 12
1
2 3
RX900.qxd 2/17/2011 1:31 PM Page 40
TOC INDEX