Nikon XX152-02-00 - Manual (Page 26)

Disassembly
The SurveyorVFT Fixed Camera Dome disassembled by removing the camera mechanism
camera mechanism while
assembling or disassembling.
1. Gently pull down on the lower il all molded tabs snap out of
place.
2.
3.
cables.
1. On outdoor version only, loosen the four (4
2. Gently pull down on the lower il all molded tabs snap out of
place.
3. Push in the tabs on the housing unt
4. Allow the SurveyorVFT to gently drop down until it is supported by the safety cord.
5. If it is necessary to complete ble connections and disconnect
the clip on the end of the safety cord from the tab on the enclosure.
can be easily
from the housing or enclosure. A safety cord is always available to safely hang the
In-Ceiling Installation
dome’s outside edge, with two hands, unt
Push in the tabs to release the camera mechanism from the enclosure. It will hang from the safety cord.
If it is necessary to completely remove the camera mechanism, disconnect the safety cord clip and all
Pendant Installation
) trim ring screws from the outdoor lower dome.
dome’s outside edge, with two hands, unt
il the camera mechanism is released.
ly remove the SurveyorVFT, remove all ca
16 • Installation XX152-02-00 Rev 1204 SurveyorVFT Fixed Camera Dome