Oregon Scientific BAR182HG - Manual (Page 11)

11
EN
For the 2nd time zone, which is indicated by the ZONE icon, enter
the hour offset using the [ ] and [ ] (CLOCK) buttons and
the BAA182HG will calculate the second zone-time accordingly.
If there is an item you do not wish to change, simply press [ MODE]
to bypass the item.
When you are done, press [ MODE ] to exit. The display will return
to the mode last chosen.
HOW TO SET AND ARM THE ALARMS
The BAA182HG has two alarms, ALARM 1 and ALARM 2. They
can be invoked together or independently.
To set an alarm:
1. Press [ ALARM ] once to select ALARM 1 or again to select
ALARM 2. T he last selected time of the alarm will be displayed.
If you have never set the alarm before, the time will be displayed
as 0:00.
2. Press [ ALARM ] for three seconds. The hour digits will
blink.
3. Enter the hour using [ ] and [ ] (CLOCK).
4. Press [ ALARM ]. The minute digits will blink.
5. Enter the minutes using [ ] and [ ](CLOCK).
6. Press [ ALARM ] to exit. The [ ] icon for the alarm
chosen will be displayed indicating the alarm set above is now
armed.
You can also arm or disarm an alarm by pressing the [ ON / OFF ]
(CLOCK) button.
When an alarm is armed, it will go off at the set time.
The four-step crescendo function allows the alarm to start off gently
and step up its intensity every 20 seconds for four times. Without
interruption, the alarm will go off for a total of two minutes. If no key
is pressed to turn off the alarm within these 2 minutes, the alarm will
go off once more after 8 minutes.
If a second alarm goes off when the first alarm is sounding off, the
first alarm will be disabled automatically.
HOW TO STOP AN ALARM
To stop an alarm, you can use either press [ ALARM ] button or
[ ON / OFF ] (CLOCK) button.
Pressing [ ALARM ] will stop the alarm, which is still armed and
will activate at the set time the following day.
If [ ON / OFF ] (CLOCK) button is pressed instead, the alarm
will be stopped and deactivated all together.
NOTE ON °C AND °F
The temperature display designation of °C or °F on the main dis-
play unit will override the display selection made on the remote
sensor. Whatever the display unit of the remote sensor is, it will
only apply to the remote sensor itself and the temperature unit will
automatically be converted to the one of the main unit. (i.e. °C)