Quick Eagle Networks 18 Volt Cordless Hammer Drill 68851 - Manual (Page 6)

Page 6 For technical questions, please call 1-800-444-3353. Item 68851
Grounding
to pRevent eleCtRiC ShoCK and death
FRom inCoRReCt GRoundinG WiRe ConneCtion:
Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded.
do not modify the power cord plug provided with the Charger. do not use the Charger if the power
cord or plug is damaged. if damaged, have it repaired by a service facility before use. if the plug will not fit
the outlet, have a proper outlet installed by a qualified electrician.
double insulated tools: tools with two prong plugs
outlets for 2-prong plug
1. Tools marked “Double Insulated” do not
require grounding. They have a special
double insulation system which satisfies
OSHA requirements and complies with
the applicable standards of Underwriters
Laboratories, Inc., the Canadian Standard
Association, and the National Electrical Code.
2. Double insulated tools may be used in either of the
120 volt outlets shown in the preceding illustration.
(See outlets for 2-prong plug.)
extension Cords
note: Extension cords must not be used with this item’s Charger.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
v~
Volts Alternating Current
a
Amperes
n0 xxxx/min. No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking concerning
Risk of Hearing Loss.
Wear hearing protection.
WARNING marking
concerning Risk of Fire.
Do not cover Charger ventilation ducts.
Charge on fireproof surface only.
WARNING marking concerning
Risk of Electric Shock.
Properly connect Charger’s power
cord to appropriate outlet.
WARNING marking concerning
Risk of Explosion.
Do not puncture, short, or open
battery packs and do not charge
damaged battery packs.
Sa
Fet
Y
o
pe
R
ation
m
aintenan
C
e
Setup