TOA Electronics C-CC714 NT - Manual (Page 27)

27
8.5. Pole Mounting Bracket Installation
The optional C-BC711PM Pole Mounting Bracket, C-BC711W Wall Mounting Bracket and YS-60B Mounting
Band are required to mount the camera on a pole.
Note
Those mounting brackets and band can be installed on a pole having a mounting pipe diameter of 90 - 340
mm. Be sure to use 2 mounting bands. If mounting band is too long, cut it.
1. Insert the optional mounting bands into the pole mounting bracket’s slots, then attach the band to a pole.
C-BC711PM
(optional)
YS-60B Mounting Band
(optional)
Hexagon head bolt
(M8, M10 or W 3/8)
2. Attach the wall mounting bracket to the pole mounting bracket.
Note: Bolts, nuts and washers for fixing are not supplied with the bracket.
Nut
Spring washer
Plain washer
C-CB711W
Wall Mounting Bracket
(optional)
YS-60B
Mounting Band
(optional)
Hexagon head bolt
(M8, M10 or W 3/8)
3. For installation procedures of the housing, camera unit and the dome cover, refer to p.20 as the procedures
are the same as that of wall mounting.