Visioneer MX 200 - Manual (Page 47)

C OPYING P HOTOS TO Y OUR C OMPUTER 41
C
OPYING
P
HOTOS TO
Y
OUR
C
OMPUTER
When connected to your computer, your digital camera behaves
like any other drive attached to your computer.
There are two ways to copy photos from your camera to your
computer: using Windows Explorer or using the Visioneer Digital
Camera Utility software. The Visioneer Digital Camera Utility
contains more options for copying and deleting photos.
To connect your camera:
1. Connect the small connector of the USB cable to the USB
port on the camera. See “Back View” on page 6 for the
position of the USB port on the camera.
2. Connect the large end of the USB cable to an empty USB slot
on your computer. To locate a USB slot, look for the USB icon
next to the connection slot.
3. Turn on the camera with the Mode dial set to any mode
except PC.
Note: Before copying photos to your computer, you must
install the software from the CD and setup your camera as new
hardware on your computer. See page 37 and page 39 for details.