VocoPro DA-900 - Manual (Page 12)

Rear Panel: Descriptions and Functions
11
1. MIC (ONLY) OUTPUT jacks - These jacks exclusively supply mixed-microphone MIC-ONLY stereo signals to external devices such as, effects units,
additional mixers or other devices. There are two MIC ONLY channels for simultaneous MIC ONLY signal feeds.
2. AUDIO (CDG/DVD) INPUT jacks - These jacks connect the stereo AUDIO OUTPUT signals from SOURCE PLAYERS (i.e. CDG, CD, DVD players)
to the DA-900.
3. MUSIC (ONLY) OUTPUT jacks - These jacks exclusively supply a MUSIC-ONLY stereo signal to an external device such as, an effects unit,
secondary mixer or other device.
4. LINE OUT jacks - This OUTPUT is for connecting the DA-900 to a secondary mixer or recording device. NOTE: Output from this jack is not affected by
the master volume control.
5. PRE-OUT jacks - These jacks are designed for a direct connection to a power amplifier. Output signals from the PRE-OUT jacks are suited for most
amplifier inputs.
6. VOLTAGE selector - This is used to set the DA-900's incoming AC POWER setting to either 110V for North American-based power supplies, and
240V for European-based power supplies. NOTE: This selector must be set correctly prior to powering on the DA-900. If this selector is set incorrectly, a
fire hazard may arise and the DA-900 may become inoperable, voiding your warranty.
7. AC POWER terminal - This AC terminal is for connecting the supplied AC POWER CORD between the DA-900 and the AC POWER OUTLET.
.
Rear Panel
CAUTION
RISK OF SHOCK
CAUTION: To reduce the risk of electric shock,
do not remove cover (or back). No user-
serviceable parts inside. Only refer servicing to
qualified service personnel.
LAVERNE CALIFORNIA
U.S.A
SERIAL NO.
MIC ONLY INPUT MIXED
CDG DVD ONLY
MUSIC
LINE PRE
OUTPUT OUTPUT OUT INPUT
1 2 3
4 5
6
7