Veo Observer - Manual (Page 5)

Page 1 of 65
Rev. 01-14-2003
1.1 Package Contents
1.2 Requirements
To connect the camera
•
LAN – 10Base-T or 100Base TX Ethernet with one RJ-45 port available
To view the camera web page
•
Web Browser – Internet Explorer 5.0 or higher
•
PC with Windows 98, Me, 2000, or XP connected to LAN
To run the included software applications
•
PC – Intel Pentium II or equivalent, 300MHz or above, 64MB RAM, 150 MB Hard Disk Space, 800x600
resolution with 16-bit color
•
Windows 98, Me, 2000, or XP
To access cameras from the Internet
•
Broadband Internet Connection (DSL, Cable Modem) with min. 128k upload speed
Before installing the Veo Observer,
please check your package contents to
ensure that all items have been
included. If any of the listed items are missing,
please contact your reseller from where you
purchased the camera for assistance.
The package includes:
1 – Veo Observer camera
1 – Mounting bracket
2 – ¼” Mounting screws and plastic anchors
1 – 10’ Power adapter
1 – 15’ Category 5 10 Mbps Ethernet cable
1 – Quick Start Guide
1 – Veo Observer camera installation CD-ROM
(located inside the Quick Start Guide)
Note: A fixed IP address is not required to access cameras from the Internet. However, if the IP
address provided by your Internet Service Provider is dynamic (changing) then signing up for a
dynamic DNS service will make accessing from the Internet much more convenient. Signing up for a
DDNS is free and easy. Please refer to Section 7.6: Dynamic Domain Name Service (DDNS) for
more information.