Vanguard Managed Solutions 650 - Manual (Page 47)

Installing and Coldloading 650 Series Software 3-9
Installing Software
2 Select TFTP. If your node is ready for TFTP
download, the following message
appears:
Optional Software Images are
DISABLED. The node is ready for
TFTP transfer.
The prompt “Network Load an
Image? (y/n):” appears. You can
then proceed to step 3.
If your node is NOT ready for
TFTP download, the following
message appears:
Optional software Images must be
DISABLED.
A node boot is required.
Disable and Boot? (y/n):
Respond to the question by
pressing the Y key.
After this, the node with
automatically reboot, and you must
return to step 1.
3 Enter Y to begin the download of
either base software or an image
option. The prompt Enter File Name:
appears.
Enter N, and proceed to step 7, if
you are enabling an option image.
4 Enter the name of the file you wish
to load on your 650. The IP address: prompt appears.
5 Enter the IP address of the TFTP
server. The prompt Ready to initiate TFTP
transfer (y/n): appears.
6 Enter Y to begin transfer of the
software. The 650 automatically reboots
when the base software download
is complete. A reboot is not needed
if you are loading an option image.
Then, return to step 1 to either load
an option image or enable an
image that was previously loaded.
7 Enter Y, when prompted with
Enable Optional Software Images?
(y/n): to enable your option image. The node automatically reboots,
and the new option image is
enabled.
Step Action Response (continued)