Vestax PMC 250 - Manual (Page 10)

9
HOW TO CHANGE THE JACK PANEL POSITION
The I/O jack panel of the PMC-250 can be placed either on the top or back side of the unit. Please
refer to following Fig.
Initially, the I/O panel is placed on the top-side. In case of changing the jack panel position to
TYPE
B , please use following instructions.
Remove 5 pieces of silver screw, which secure
the PANEL .
Remove 5 pieces of silver screw, which secure
the PANEL .
Install the PANEL 1 to the back side and secure
it with 5 silver screws.
Install the PANEL 2 to the top side and secure it
with 5 silver screws.
CAUTION
Please ensure use of the proper screwdriver
(3mm Phillips type). Please hold the
screwdriver upright and turn slowly. Do not use
excessive force, or it may damage the screw
head.