Audio output, Figure 3-11 . audio output connection, Speakers – Vidikron VP-6000a User Manual
Page 34: Figure 3-12 . connecting speakers, 11. audio output connection, 12. connecting speakers, Figure 3-11, Pre l iminar y
24
Vidikron PlasmaView Owner’s Operating Manual
PRE
L
IMINAR
Y
Audio Output: The PlasmaView has a stereo audio output for connection to an external A/V
receiver or powered speakers. The audio signal corresponding to the selected video input is
output to both the speakers and this audio output.
Use a stereo miniplug to connect the PlasmaView stereo audio output to your external audio
equipment; see Figure 3-11.
Figure 3-11. Audio Output Connection
Speakers: The PlasmaView has an internal, 8W per channel stereo amplifier that can drive a
pair of stereo speakers. Connect the
(positive) and
(negative) speaker wires to the EXT
SPEAKER terminals on both the LEFT and RIGHT channels; see Figure 3-12. Maintain the
correct polarity. For more information, refer to the owner’s manual for your speakers.
Figure 3-12. Connecting Speakers
The audio output level is fixed. (The volume and mute controls affect only
the speaker outputs.)
Note
AUDIO AUDIO
INPUT1
AUDIO
OUTPUT
INPUT2
m
m
2
1
Twist exposed
wire strands
together.
Push tab to the open
position, and insert the
wire. Then, close tab
firmly to secure the wire
in place.