Vermont Castings FK28/2960 - Manual (Page 5)

5 30000275
Seville Installation Procedure
Install the Snapstat
1. Disconnect the leads from the Snapstat terminals.
2. Use pliers to remove the retainer ring from the
Snapstat Cover and slip the cover off the wire har-
ness.
3. Reconnect the wire leads to the Snapstat Plate.
4. Using two sheet metal screws from the fan kit, attach
the Snapstat Plate to the Inner Shroud as indicated
in Figure 17.
Install the Fan
Position the Fan body within the Rear Shroud as shown
in Figure 18. The Fan’s upper flange should be located
behind the lip of the opening. Secure the Fan to the
Shroud using five sheet metal screws and single star
washer supplied with the kit.
Install the Rheostat Switch
1. Install the Switch within the Switch Bracket that is
provided with the stove in the Hardware Bag. Use
the Retainer Nut and Control Knob provided in the
Fan Kit. (Fig. 19)
2. Attach the Switch Bracket to the left side of the Rear
Shroud using two sheet metal screws as shown in
Figure 20.
3. Secure the fan wire harness to the back of the
Shroud using the Wire Tie plug as shown in Figure
20.
ST462
seville
install fan
Fig. 18 Install fan body into rear shroud.
ST462
ST463
Seville
install
Rheostat switch
Switch Bracket
Retainer Nut
Control Knob
Switch Box
ST463
Fig. 19 Install the rheostat switch.
ST462
seville
install fan
Insert Wire Tie
Here
ST462
Fig. 20 Attach the rheostat switch and wire tie.
St464
Seville
Install snapstat
Snapstat Plate
Leads
Snapstat
Cover
ST464
Fig. 17 Install snapstat.