VIEWSONIC VS13172 - Manual (Page 22)

ViewSonic VOT125 14
„ Main Menu
The BIOS Setup is accessed by pressing the DEL key after the Power-On Self-Test
(POST) memory test begins and before the operating system boot begins. Once you
enter the BIOS Setup Utility, the Main Menu will appear on the screen. The Main
Menu provides System Overview information and allows you to set the System Time
and Date. Use the “<” and “>” cursor keys to navigate between menu screens.
Table 2 BIOS Main Menu
BIOS SETUP UTILITY
M a i n A d v a n c e d B o o t C h i p s e t P o w e r S e c u r i t y E x i t
System Date [Wed 10/21/2009]
System Time [10:18:15]
> SATA 1 :[WDC WD1600BEV]
> System Information
Use [ENTER], [TAB]
or [SHIFT-TAB] to
select a field.
Use [+] or [-] to
configure system Time.
<> Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
V02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
Below table is described for SATA 1 setting.
Table 3 IDE Device Setting Menu
BIOS SETUP UTILITY
M a i n A d v a n c e d B o o t C h i p s e t P o w e r S e c u r i t y E x i t
Primary Master
Device :Hard Disk
Vendor :WDC 1600BEVT-00ZCT0
Size: :160.0GB
LBA/ Large Mode [Auto]
DMA Mode [Auto]
S.M.A.R.T [Auto]
Disable: Disables LBA Mode.
Auto: Enables LBA Mode if the
device supports it and the
device is not already formatted
with LBA Mode disabled.
<> Select Screen
↑↓ Select Item
+- Change Field
Tab Select Field
F1 General Help
F10 Save and Exit
ESC Exit
V02.61 (C)Copyright 1985-2006, American Megatrends, Inc.
LBA/ Large Mode [Auto]
Enables or disables the LBA (Logical Block Addressing)/ Large mode. Setting to
Auto enables the LBA mode if the device supports this mode, and if the device was
not previously formatted with LBA mode disabled.
Options: Disabled, Auto