VocoPro SUB-1200 - Manual (Page 14)

Glossary of Terms
Y-Adapter - Any type of connection that splits a signal into two parts. An example would be a connector with one
male RCA jack on one end, and two female RCA jacks on the other end.
Woofer - A speaker, (driver), used for low-frequency reproduction. Usually larger and heavier than a midrange or
tweeter.
Midrange - A speaker, (driver), used to reproduce the middle range of frequencies. A midrange is combined with
a woofer for low frequencies and a tweeter for high frequencies to form a complete, full-range system.
Tweeter – A speaker, (driver), used to reproduce the higher range of frequencies. To form a full-range system, a
tweeter needs to be combined with a woofer, (2-way system), or a woofer and midrange, (3-way system).
Pre-Amplifier - Or Pre-amp is a device that takes a source signal, such as from a turntable, tape-deck or CD
player, and passes this signal on to a power-amplifier(s). The pre-amp may have a number of controls such as
source selector switches, balance, volume and possibly tone-controls.
Out of Phase - When speakers are mounted in reverse polarity, i.e., one speaker is wired +/+ and -/- from the
amp and the other is wired +/- and -/+. Bass response will be very thin due to cancellation.
Line Level - CD players, VCRs, Laserdisc Players etc., are connected in a system at line level, usually with
shielded RCA type interconnects. Line level is before power amplification. In a system with separate pre-amp and
power-amp the pre-amp output is line level. Many surround sound decoders and receivers have line level outputs
as well.
Frequency - The range of human hearing is commonly given as 20-20,000Hz (20Hz-20kHz). One hertz (Hz)
represents one cycle per second, 20Hz represents 20 cycles per second and so on. Lower numbers are lower
frequencies
Gain - To increase in level. The function of a volume control.
Decibel (dB) - Named after Alexander Graham Bell. We perceive differences in volume level in a logarithmic
manner. Our ears become less sensitive to sound as its intensity increases. Decibels are a logarithmic scale of
relative loudness. A difference of about 1 dB is the minimum perceptible change in volume, 3 dB is a moderate
change in volume, and about 10 dB is an apparent doubling of volume. 0 dB is the threshold of hearing and 130
dB is the threshold of pain.
Cipping - Refers to a type of distortion that occurs when an amplifier is driven into an overload condition. Usually
the "clipped" waveform contains an excess of high-frequency energy. The sound becomes hard and edgy. Hard
clipping is the most frequent cause of "burned out" tweeters. Even a low-powered amplifier or receiver driven into
clipping can damage tweeters which would otherwise last virtually forever.
13