VTech I6725 - Manual

STEP 1 Check package contents
Make sure your phone’s packaging includes the following:
STEP 3 Battery installation
1. Align the two holes in the plug with the socket pins,
then snap the plug into place. Place the battery in the
compartment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it clicks into
place.
STEP 4 Charge the battery
1. Place the handset in the base unit/charger.
2. Charge the battery for at least 16 hours before first use.
Quick Start Guide
i6725
STEP 2 Connect power to telephone base/charger
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base/charger.
NOTE:
• Use only the power adaptors supplied with your
VTech telephone.
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
IMPORTANT!
If your product is not working properly:
1. Refer to your user’s manual.
2. Visit our website at www.vtechphones.com or www
vtechcanada.com in Canada.
3. Call our customer service at 1-800-595-9511 or 1-800-267
7377 in Canada.
Hanging up
Press OFF or place the handset in its
base/charger.
NOTE:
For complete feature instructions, please refer to your
user’s manual.
Base unit Handsets (2)
Telephone
line cord
Batteries (2)
Belt clips (2) Wall mount
bracket
Base power adaptor
Charger power adaptor
User’s manual
Charger
Quick start
guide
STEP 6 Making and receiving calls
Making a call
• Press TALK/FLASH or SPEAKER and listen for dial
tone.
• Dial the phone number.
-OR-
• Dial the phone number.
• Press
TALK/FLASH.
Receiving a call
Press TALK/FLASH, SPEAKERPHONE, or any dialing key
except OFF.
96-006081-010-000
Issue 0