Volvo MOTOR GRADERS G930 - Manual (Page 5)

5
G930
Frame
Front
Minimum dimensions of box section
in (mm) 10.5 x 13.5 (265 x 340)
Plate thickness in (mm) .79 (20)
Vertical section modulus at arch cu in (cm 3 ) 119 (1 950)
minimum cu in (cm 3 ) 101 (1 663)
maximum cu in (cm 3 ) 212 (3 474)
Rear
Minimum dimensions
in (mm) 10 x 4 (254 x 100)
Plate thickness in (mm) .38 (9,6)
Optional fi rst user lifetime warranty on frame, includes maintenance free articulation pins and bearings.
Moldboard
Standard moldboard with replaceable end bits in
(mm)
.87 x 25 x 12'
(22 x 635 x 3 658)
Moldboard material SAE 1050 high carbon steel
Edge: through hardened in (mm) 6 x 5/8 (152 x 16) boron steel
Bolt spacing in (mm) 6 (152)
Bolt size in (mm) 5/8 (16)
Slide rails supported by Duramide™ bearings
Moldboard range: Moveable Blade Control System
(Dimensions shown with 14:00 tires and standard moldboard) Left/Right
Reach outside tires - articulated frame in
(mm)
120/119.5
(3 048/3 035)
Reach outside tires - straight frame in
(mm)
80/79
(2 020/2 010)
Moldboard slide in
(mm)
26.5/26.5
(673/673)
Circle side shift in
(mm)
30.5/29.5
(775/749)
Maximum bank sloping angle, left - right degrees 90º/90º
Moldboard ground clearance in (mm) 17.5 (445)
Moldboard cutting depth in (mm) 31 (790)
Moldboard tilt range degrees forward
degrees back
47º
5º
Superior moldboard mobility permits steep ditch cutting angles and back sloping outside overall machine width.
2007.05
036-454 Q4 930 web specs R2.indd 6 036-454 Q4 930 web specs R2.indd 6 5/9/07 12:02:40 PM 5/9/07 12:02:40 PM