Vidikron VP-42HD - Manual (Page 31)

Vidikron PlasmaView Owner’s Operating Manual 21
PRE
L
IMINAR
Y
4.1
Turning on the Power 1. Turn on your source components.
2. Attach the two ferrite cores supplied with the display to each end of the AC power cable
as shown in Figure 4-1. Doing so will reduce radio frequency interference (RFI) emissions
to a level that conforms to FCC regulations. Use the supplied plastic bands to secure the
cores in place.
Figure 4-1. Attaching the Ferrite Cores to the Power Cable
3. Plug the female end of the power cord into the AC receptacle on the rear of the
PlasmaView (AC 100V ~ 240V). Connect the other end to your AC power source.
4. Press the POWER button on the underside of the PlasmaView. The power indicator lights
solid green.
5. After a brief warm-up period (approximately 10 seconds), the PlasmaView will display an
image.
4.2
Changing the OSD
Language The PlasmaView OSD language is initially set to English, but can also display the menus in
German (Deutsch), French (Français), Spanish (Español) or Italian (Italiano). To change the
OSD language:
1. Press MENU.
2. Select Install from the Main Menu.
3. Select Language from the Install Menu.
4. Press right- or left-arrow button ( or ) to highlight the desired language and press
MENU. The change takes effect immediately.
4
Operation
Power cable
Ferrite Core
Ferrite Core