Vicks V940 - Manual (Page 11)

Changing Scale Between (°F) and (°C):
The Thermometer can display temperature in either Fahrenheit or Centigrade. To
change the scale, follow the instructions below:
1. Start with the thermometer turned off.
2. Simultaneously, press and hold the Mode ( ) and
Memory ( ) buttons for approximately 2 seconds.
Release buttons after the beep. The display will first show
the previously used scale. Press the Mode (
) button to
switch to the alternate scale (Fig. 7).
3. When the “hourglass” symbol ( ) disappears, the
thermometer is ready to measure by the selected measurement scale.
NOTE: If thermometer is turned off before a measurement is taken after the
scale change, the scale will revert to the one last used.
Memory Mode:
When the unit is off, you can enter Memory Mode by pressing
the Memory (
) button.
Press the Memory ( ) button again to recall up to 10 past
measurements (Fig. 8). The readout will indicate the
temperature, elapsed time since the reading and measuring
location.
DIRECTIONS FOR USE (cont’d)
Fig. 7
Fig. 8
11
V940 OM.qxd 12/28/05 11:17 AM Page 11