VXI Powerline Amplifier - Manual (Page 4)

STEP 1:
Connect the Cords-
Connection for Electronic Phones
(Figure 1)
1. Disconnect your telephone cord from the back of your
telephone and insert it into the Wall Line Jack . This jack
will accept both 8-position and 6-position modular plugs.
2. Plug the gray cord into the Phone Line Jack on the
amplifier
. Plug the free end of this cord into the
now vacant jack on your phone.
3. Remove the coiled handset cord from your
telephone and plug it into the jack marked .
4. Connect one end of the black cord into the now
empty handset jack on your phone. Connect the
other end of this cord into the jack marked
.
Connection for Carbon Phones
(Figure 2)
1. Remove the coiled handset cord from your telephone and
plug it into the jack marked .
2. Connect one end of the black cord into the now empty
handset jack on your phone. Connect the other end of this
cord into the jack marked
.
4
STEP 2:
Connecting the Headset
The Powerline headset port is compatible with the
supplied VXI lower cord, and is also compatible with
GN Netcom
®
and Fellowes
®
headsets (please see
instructions below for installation requirements).
Connecting a VXI Headset
Connect the VXI headset to the lower coil cord
provided with the amplifier and insert modular plug
into the front port of the amplifier (Figure 3).
Connecting a GN Netcom or Fellowes Headset
Connect the GN Netcom or Fellowes headset, including
its lower cord, by inserting modular plug into the front
port of the amplifier (Figure 3).
Discard the VXI-provided lower cord.
STEP 3:
Setting up the Headset/Handset
Set the headset/handset switch to the headset position
(Figure 4).
Figure 4
Figure 1
VXI TuffSet Powerline Amplifier – Instruction Guide
Figure 2
Figure 3
Follow instructions below
for your phone type.