Visioneer 9520 - Manual (Page 23)

16 V ISIONEER O NE T OUCH 9520 P HOTO S CANNER U SER ’ S G UIDE
If you are using Windows XP and have plugged the USB cable into
a USB 1.1 port, an information bubble may open explaining that
“A HI-SPEED USB device is plugged into a non-HI-SPEED USB
hub”. Plug the USB cable into a USB 2.0 port (if available) or just
disregard the message. If you leave it plugged into the USB 1.1
port, your scanner may scan a bit slower than with a USB 2.0 port.
Your computer recognizes that a scanner has been plugged into the
USB port. If your computer is running Windows XP or Windows
Vista, you will see the Found New Hardware message.
The computer loads the appropriate software from the CD to run
the scanner.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. For Windows
XP and Windows Vista, you will see a message similar to the following,
that your new hardware is found and ready to use.