Venturer PLV16198 - Manual (Page 11)

E - 10
CONNECTIONS
CONNECTING A HIGH-DEFINITION (HD) SOURCE
High-Definition (HD) devices with component video output must be connected to the YUV input.
Connect the component video cable and audio cable (not included) as shown.
Make sure you connect the component video cable and audio cable from the other equipment (COMPONENT
VIDEO OUT and AUDIO OUT) to this unit (COMPONENT VIDEO IN and AUDIO IN - YUV IN).
NOTE:
When connecting a DVD player to the television, the picture resolution is solely dependent upon the
resolution supported by the DVD player attached. DVD player resolutions vary from 480i to 1080i, and
this unit can support DVD players up to a maximum resolution of 1080i.
CONNECTING A PC
Connect the 15-pin D-SUB PC/VGA connector from your computer to the 15-pin D-SUB PC/VGA input on
this unit using a monitor cable and audio cable (not included) as shown.
Make sure you connect the
cable from the computer (PC
Connector and AUDIO - PC
OUT) to this unit (MONITOR /
VGA and AUDIO - PC IN).
To AUDIO jack (PC OUT)
* May require a subscription
for receiving HD channels.
Check with your cable/
satellite service provider for
details.
To AUDIO IN
jacks
(YUV IN)
To AUDIO
OUT jacks
To COMPONENT
VIDEO IN jacks
(YUV IN)
To COMPONENT
VIDEO OUT jacks
To PC connector
PLV16198S2_01-11.pmd 9/7/2007, 12:30 PM 10