Verizon 7500 - Manual (Page 93)

030-300536 Rev. A 93 August 2007
User Guide VersaLink Wireless Gateway (Model 7500)
14.2.3.3.2 Configuring the Ethernet WAN Uplink Protocol Settings for Routed IP
If you select Routed IP from the Protocol drop-down menu, the following screen will appear. Enter the desired
options, and then click Apply to save the settings.
NOTE:
1. If you experience any problems, reset the Router by pressing the reset button on the rear of the Router. Or follow
the instructions in section 16.2, “Restore Defaults,” to restore the Router to factory default settings. The actual
information displayed in this screen may vary, depending on network connection established.
2. PPPoE is the factory default setting for Ethernet WAN Uplink.