Garmin GPSMAP 3005C - Manual (Page 80)

 GPSMAP 3005C Owner’s Manual
u
sIng
s
onAr
> u
nderstAndIng
s
onAr
u
sInG
s
onar
This section covers the additional options for the GPSMAP 3005C when used
with a GSD 20, GSD 21 or GSD 22 Sounder Module. Read the installation
instructions included with your Garmin Sounder Module to install it.
NOTE: You must have a GSD 20, GSD 21, or GSD 22 Sounder Module
installed and connected to your GPSMAP 3005C to use the sonar features.
Understanding Sonar
The transducer mounted on your vessel sends sound waves down into the water
in a cone shape, similar to a flashlight beam (covering a smaller circular area at
the top and angling out to a larger circular area at the bottom). These sound waves
reflect off of any object that they hit, and then the waves travel back up to the
transducer. These objects could be fish, branches, the bottom, or any other object
that has density that is different from the water. The transducer receives the sound
wave information, and then sends the information to the GSD 20, GSD 21, or
GSD 22 sounder module and then to the GPSMAP 3005C. The
GPSMAP 3005C displays the information on the screen for you to see and
interpret. The type of transducer and the settings that you choose determine how
the information is displayed on the screen.
Using Dual Frequency
Dual frequency works best for deep water (for example, off-shore) applications.
The 200 kHz frequency allows you access to great detail about what is underneath
your boat. The 50 kHz frequency provides less detailed information, but
penetrates to greater depths with the same power. You can choose either or both
frequencies to get the information that you want. If you choose dual frequency,
the transducer alternates between the 50 kHz and 200 kHz signals. This capability
allows you to see the best picture available at any depth.
Using Dual Beam
Dual beam works best for shallow water (inland) applications. A dual beam
transducer can transmit a narrow or a wide beam. The water area covered by the
transmitted sound waves is determined by the beam width of the transducer and
the water depth. The narrow beam provides crisp detail of what is under your
boat, and is very helpful if you are fishing in deeper water where the beam covers
more area (for example, at a 30-foot depth, the narrow beam covers the area of
about a 7-foot circle).
Wde
Beam
Narrow
Beam
s
onar