Garmin GPSMAP 76S - Manual (Page 7)

6
While learning the basic operation of the GPSMAP 76S, let’s put the unit
into Simulator Mode. The Simulator Mode is great for practicing with the unit
while inside and satellite signals are not available. When the GPSMAP 76S is in
Simulator Mode, the GPS receiver is turned off (this will help conserve battery
power) and the unit cannot be used for actual navigation.
NOTE: Do not try to navigate using the Simulator Mode. While in the
Simulator Mode, the GPS receiver is turned off. Any Satellite Signal
Strength Indicators displayed are only simulations and do not indicate
the strength of actual satellite signals.
Activating the Simulator Mode
Press the POWER key to turn the unit on. The Welcome Page will be
displayed, press the PAGE key twice to display the GPS Information Page.
Putting the GPSMAP 76S in Simulator Mode:
1. With the GPS Information Page displayed press the MENU key.
2. Using the ROCKER key, highlight ‘Start Simulator’ then press the ENTER key
to activate the simulator.
When the Simulator Mode is active, the message ‘Simulating GPS’ will be
displayed along the top of the GPS Information Page.
Highlighted Field
Quick Start
Using the Built-in Simulator
!
190-00249-01_0A.indd 6 9/1/2004, 10:58:36 AM