Garmin GPSMAP 2210 - Manual (Page 30)

22 GPSMAP 2206/2210 Owner’s Manual
b
AsIc
o
PerAtIon
> n
AvIgAtIng to A
d
estInAtIon
5. To change the name of the saved track, highlight the Name field and press
ENTER, make any changes, and press ENTER again.
6. To specify the color used to show the saved track line on the map and
highway, highlight the Color field and press ENTER, choose a color, and
press ENTER again.
7. To show the track on the Map and Highway Pages, highlight the check box
to the left of Show on map and highway, and press ENTER.
8. Press the OK soft key to save the track log.
To review and edit a track:
1. On the Saved sub tab, highlight a track and press ENTER to open the
Saved Track Page.
2. Make any changes, and then press QUIT.
Initiating a Follow Track
You must save a track before using the Follow Track option. If there are no saved
tracks, the message “There are no Saved Tracks to follow” appears.
To follow a track using the NAV key:
1. Press NAV, highlight Follow Track, and press ENTER. The Select Track
Page appears.
2. Highlight the track you want to follow, and press ENTER.
3. To invert the Follow Track (navigate it in the reverse direction), press NAV,
highlight Invert Route, and press ENTER.
To start a TracBack using the NAV key:
1. Press NAV to open the Navigation menu.
2. Highlight TracBack, and press ENTER. The TracBack Through window
appears.
3. Highlight the time, date, or Entire Log, and press ENTER.
To stop TracBack navigation:
1. Press NAV.
2. Highlight Stop Navigation, and press ENTER.
TracBack Tips
When a TracBack is active, the GPSMAP 2206/2210 takes the track log stored
in memory and divides it into segments called legs. Up to 300 temporary turns
(BEGIN, TURN 1, TURN 2,...., TURN X, END) are created to mark the most
significant features of the track log to duplicate your exact path as closely as
possible. To get the most out of the TracBack feature, remember the following
tips:
• Always clear the track log at the starting point.
• The Record Mode option on the track log setup page must be set to
Fill or
Wrap.
• At least two track log points must be stored in memory to create a
TracBack route.
• If the track log Interval field is set to Time, the route may not follow your
exact path (keep the interval set to Resolution for best performance).
• If the receiver is turned off or satellite coverage is lost during your trip,
TracBack draws a straight line between any point where coverage was lost
and where it resumed.
• If your track log’s changes in distance and direction are too complex,
300 waypoints might not mark your path accurately. The receiver then
assigns the 300 waypoints to the most significant points of your track, and
simplifies segments with fewer changes in direction.