Settings on copy/move clips, Clip mode/cam mode, Default settings – EVS XTnano Version 10.04 - January 2011 Operation Manual User Manual
Page 45: How to copy or move a clip
XTnano – Version 10.04 – Operating Manual
EVS Broadcast Equipment SA – January 2011
Issue
10.04.A
37
S
ETTINGS ON
C
OPY
/M
OVE
C
LIPS
When you copy/move a clip, two settings are available to specify how the clip
should be copied or moved:
Clip Mode/Cam Mode
Pressing the D key in the Copy/Move LCD window allows the user to select a value
for this setting:
•
CLIP mode: all camera angles of the clips will be copied/moved.
•
CAM mode: only the camera angles of the clip loaded on the controlled
channels will be copied/moved.
Default Settings
The default settings for the COPY/MOVE menu are: COPY and CLIP. If the
operator changes these settings, the new settings will be re-used the next time
this menu is called. The default settings will be automatically restored when
starting a new Multicam session.
H
OW TO
C
OPY OR
M
OVE A
C
LIP
It is possible to copy or move a clip on the same server. Growing clips can also be
copied and moved.
To copy or move a clip from the Remote Panel, proceed as follows:
1.
Select the original clip.
2.
Select an empty location on the same EVS server.
3.
A new menu appears on the LCD display of the Remote Panel, with the
corresponding message on the OSD of the output monitors:
4. Select
the
COPY or MOVE function by pressing the A or B key.
The corresponding function will be highlighted on the LCD and the message
on the OSD will be updated accordingly.
5.
Select the CLIP or CAM mode with the D key.
See Section “Settings on Copy/Move Clips” below.
6. Press
ENTER to confirm or MENU to cancel.