Velleman ALN006 - Manual (Page 19)

16
English
6.7.a Connection
1) Connect the two ends of the programming cable to the MIC
connectors of both radios.
6.7.b Enabling the Cloning feature
On the radio you wish to program (that receives the data):
1) Press MENU till the display shows CL (cloning)
2) Press q. CL displays followed by rE (receipt).
3) Press once more q. The status LED lights in green to indicate
that the radio is ready to receive the data.
On the programmed radio (that has already been programmed):
1) Press MENU till the display shows CL (cloning)
2) Press p. CL displays followed by tr (transmission).
3) Press once more p. The status LED flashes in red and the data
transfer is started.
4) At the end of the transfer operation, P displays on the radio that
has received the data.
5) Press MENU on both radios to exit.
7. Connecting the audio accessories
To connect the optional microphones:
1) Verify that the radio has been switched off.
2) Loosen the screw [20] that fixes in place the protective cover [21]
of the microphone connectors.
3) Remove the protective cover of the microphone connectors by
pushing the section labelled PUSH upwards.
4) Insert the jack of the microphone into the SPK and MIC slots of
the radio.
To protect the MIC/SPK jacks (if not used), you can fix the supplied
rubber cap: in this way you avoid fixing and removing again the
plastic protective cover. Before fixing the rubber cap to the radio,
insert the washer between the cap and the screw.