Ingalls 35200 User Manual
Ingalls For the car
Advertising
Installation Instructions
1.
Check & document initial alignment readings.
2.
Remove upper cam bolt from strut assembly.
3.
Install new camber bolt, cam, lock washer and nut.
NOTE: Some OE bolts use only one cam per cam bolt. The
replacement bolt has a cam on both sides of the strut.
4.
Loosen lower strut bolt slightly.
5.
Adjust camber to specifications by turning cam bolt.
6.
Tighten upper camber adjuster nut while holding the bolt
steady.
NOTE: Check to be sure that they are seated flat against the strut
flanges before tightening the cam bolt nut.
7.
Tighten lower strut bolt.
8.
Repeat procedure on opposite side.
9.
Adjust toe.
ING3520-72497
Copyright © 1997-04 Ingalls Engineering Co., Inc.
Advertising