Prokit's Industries MT-7810 User Manual
Mt-7810 satellite finder kit, User guide
MT-7810 SATELLITE FINDER KIT
USER GUIDE
INTRODUCTION
THANK YOU VERY MUCH FOR BUYING OUR SATELLITE FINDER KIT WHICH WILL HELP YOU TO RECEIVE
SATELLITE PROGRAMS AS YOU WISH WITH YOUR TV WITHOUT ANY PROBLEM.
PLEASE USE THIS ACCORDING TO THE FOLLOWING PROCESS TO SET UP YOUR SATELLITE ANTENNA.
1. BEFORE BEGINNING TO SET UP A SATELLITE ANTENNA, YOU SHOULD CHOOSE A SUITABLE PLACE FOR IT.
SUCH AS, ON THE WALL, ROOF, OR IN THE GARDEN, ETC. KEEP IN MIND THAT THE DISH SHOULD HAVE A
WIDE-OPEN OF VIEW OF THE SKY IN THE DIRECTION OF THE SATELLITE (ASK YOUR PROVIDER).
2. PLEASE REFER TO THE TABLE BELOW TO DETERMINE THE DIRECTION AND AZIMUTH OF THE SATELLITE
YOU WISH TO RECEIVE.
3. PLEASE USE ACCORDING TO THIS INSTRUCTION MANUAL FOR ALL THE REQUIRED ADJUSTMENTS.
160˚W-73˚E
73˚E-0˚E
0˚W-61˚W
61˚W-160˚W
Satellites:
Asia
Europe
Atlantic
America
Packages:
Asia
Europe
Atlantic
America
HD TV:
Asia
Europe
Atlantic
America
SatTracker:
Asia
Europe
Atlantic
America
For more details, go to
OPERATION MANUAL
1. FIX LNB TO DISH FIRST.
2. CONNECT A RF JUMPER CABLE FROM LNB TO LEFT SIDE OF SATELLITE FINDER (“TO LNB” TERMINAL).
3. CONNECT BATTERY PACK TO RIGHT SIDE OF THE SATELLITE FINDER (“TO REC/DC 15V” TERMINAL).
4. THE NEEDLE OF THE METER SHOULD INDICATE MOVEMENT WITHIN THE FULL SCALE OF THE METER
(BETWEEN 0 AND 10, AND THE SCALE WILL LIGHT UP.
5. REFER TO TABLE ABOVE AND MAKE COARSE DISH ALIGNMENT BY SETTING AZIMUTH AND INCLINATION.
6. SET THE NEEDLE OF THE METER ON THE MIDDLE SCALE BY ADJUSTING SATELLITE FINDER’S
“SENSITIVITY CONTROL” ADJUST THE ANGLE AND DIRECTION OF THE DISH, IF YOU CATCH THE SIGNAL,
THE NEEDLE WILL JUMP TO NEAR FULL SCALE.
7. ADJUSTING THE “SENSITIVITY CONTROL” KNOB COUNTERCLOCKWISE, SET NEEDLE ON THE MIDDLE OF
THE SCALE. REPEATEDLY ADJUST THE DISH AND “SENSITIVITY CONTROL” KNOB UNTIL YOU GET THE
BEST RECEPTION.