Asus P5N-T Deluxe - Manual (Page 52)

2-26 Chapter 2: Hardware information
3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA hard disk
drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID
1, RAID 0+1, RAID 5, or JBOD configuration with the onboard NVIDIA ®
MediaShield™ RAID controller.
The RAID function of these connectors is set to [Disabled] by default. If you
intend to create a Serial ATA RAID set using these connectors, enable the RAID
Enabled item under the Serial ATA Configuration sub-menu in the BIOS.
These connectors support Native Command Queuing (NCQ), Power
Management (PM) Implementation Algorithm, Hot Swap and smart setup.
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
P5N-T DELUXE
®
P5N-T DELUXE SATA connectors
SATA6 SATA5
GND
RS
AT
A_TXP6
RS
AT
A_TXN6
GND
RS
AT
A_RXP6
RS
AT
A_RXN6
GND GND
RS
AT
A_TXP5
RS
AT
A_TXN5
GND
RS
AT
A_RXP5
RS
AT
A_RXN5
GND
SATA3 SATA4
GND
RS
AT
A_TXP3
RS
AT
A_TXN3
GND
RS
AT
A_RXP3
RS
AT
A_RXN3
GND GND
RS
AT
A_TXP4
RS
AT
A_TXN4
GND
RS
AT
A_RXP4
RS
AT
A_RXN4
GND
SATA2 SATA1
GND
RS
AT
A_TXP2
RS
AT
A_TXN2
GND
RS
AT
A_RXP2
RS
AT
A_RXN2
GND GND
RS
AT
A_TXP1
RS
AT
A_TXN1
GND
RS
AT
A_RXP1
RS
AT
A_RXN1
GND